Cisco
500-007 · Question #39
How should you configure the IP address and default gateway on a Cisco TelePresence MCU 5300 Series device during setup?
The correct answer is B. Console into the serial port in the front panel, and use the static command. See the full explanation below for the reasoning.
Question
How should you configure the IP address and default gateway on a Cisco TelePresence MCU 5300 Series device during setup?
Options
- AConnect an Ethernet cable to the second Ethernet port of the MCU, and point your web
- BConsole into the serial port in the front panel, and use the static command.
- CUse the arrows next to the LCD in the front to change the IP address, subnet mask, and
- DChange it from the Cisco VCS.
How the community answered
(22 responses)- A5% (1)
- B77% (17)
- C14% (3)
- D5% (1)
Community Discussion
No community discussion yet for this question.