Cisco
500-005 · Question #13
After DHCP is enabled and a new TX9000 system is configured in Cisco Unified Communications Manager, the TX9000 displays an IP address of 192.168.100.2, which is not what was expected. Which of…
The correct answer is F. DHCP is enabled in Cisco Unified Communications Manager. See the full explanation below for the reasoning.
Question
After DHCP is enabled and a new TX9000 system is configured in Cisco Unified Communications Manager, the TX9000 displays an IP address of 192.168.100.2, which is not what was expected. Which of these should be verified in your troubleshooting of the issue?
Options
- AYour static IP address is configured.
- BDNS is configured properly.
- CTFTP is enabled in Cisco Unified Communications Manager.
- DThe device is configured to use SCCP.
- EThe device is on a subnet that is separate from Cisco Unified Communications Manager.
- FDHCP is enabled in Cisco Unified Communications Manager.
How the community answered
(27 responses)- A11% (3)
- B7% (2)
- C4% (1)
- E4% (1)
- F74% (20)
Community Discussion
No community discussion yet for this question.