4A0-M02 Exam Questions
134 real 4A0-M02 exam questions with expert-verified answers and explanations. Page 2 of 3.
- Question #54
Which of the following statements is FALSE regarding the Gx interface?
- Question #55
Which of the following statements is FALSE regarding the EPC QoS parameters?
- Question #56
On the Alcatel-Lucent 7750 PGW, which of the following is the default setting of the APN "selection-mode"?
- Question #57
Which of the following most accurately describes the QCI / ARP?
- Question #58
Based on the information shown in the exhibit, which of the following is TRUE when the PGW receives a "Create Session Request" with the "PDNTYPE" set to IPv4?
- Question #59
Based on the information shown in the exhibit, which of the following is the MBR/GBR value for Bearer 6 in the DL direction?
- Question #60
When a UE is roaming, which of the following interfaces is used when the visiting SGW needs to communicate with the UE's home PGW?
- Question #61
Which of the following statements is FALSE regarding the UE network attachment procedure?
- Question #62
Which of the following messages are exchanged between the PGW and the PCRF during the UE attachment procedure?
- Question #63
A PGW may use various methods to assign an IP address to a UE. Which of the following methods is supported on Alcatel-Lucent 7750 PGW? (Choose the best answer)
- Question #64
There is an active GTP path between an Alcatel-Lucent SGW and an Alcatel-Lucent PGW, On the SGW. Which of the following CLI commands is used to check the "Restart Count" value of t...
- Question #65
Which of the following messages are exchanged between the MME and the SGW during the UE attachment procedure? (Choose two)
- Question #66
Which of the following statements is FALSE regarding Key Performance Indicator/Key Capacity Indicator (KPI/KCI)?
- Question #67
Which of the following parameters best describes the rate-limiting associated with a Non- GBR bearer?
- Question #68
On the Alcatel-Lucent 7750 MG, which of the following is the CLI command to check the active / standby state of the MG-ISM cards?
- Question #69
On an Alcatel-Lucent 7750 MG, which of the following best describes the protect-active- delay timer configured for an MG-ISM group?
- Question #70
Which of the following interfaces is not using the GTP-C protocol?
- Question #71
Which of the following statements are FALSE regarding the SGW? (Choose two)
- Question #72
Which of the following statements is FALSE regarding the keep alive messages exchanged between the CPM card and an MG-ISM card?
- Question #73
Which of the following statements is TRUE when a registered UE goes idle?
- Question #74
Based on the information shown in the exhibit, which of the following is the PLMN ID?
- Question #75
On Alcatel-Lucent 7750 SGW, which of the following CLI commands can be used to check the connectivity to the GTP peer?
- Question #76
Based on the information shown in the exhibit, when the SGW sends a downlink user data packet to the UE, which of the following is the source IP address expected in the IP packet?
- Question #78
Assume that dynamic PCC rules are used on the PGW. When the UE sends a request to establish a dedicated bearer, which of the following messages are exchanged between the PCRF and t...
- Question #79
Which of the following LTE interfaces are used for the communication of user data? (Choose one best answer)
- Question #80
On Alcatel-Lucent 7750 PGW, which of the following CLI commands can be used to check the IP addresses assigned to a particular UE?
- Question #81
Based on the information shown in the exhibit, which of the following is the time interval used by the SGW to send out an "Echo Request" message over the GTP interface?
- Question #82
Which of the following statements are TRUE regarding the SDF templates /filters? (Choose three)
- Question #83
During an S1-based handover with MME relocation, which network entity requests the creation of an indirect data forwarding tunnel by sending a "Create Indirect Data Forwarding Tunn...
- Question #84
Based on the information shown in the exhibit, when the SGW sends an uplink user IP packet to the PGW, which of the following is the GTP TEID value expected in the GTP packet heade...
- Question #85
On Alcatel-Lucent 7750 SGW, which of the following statements is FALSE regarding the debugging of a given IMSI?
- Question #86
Which of the following resources are freed when a registered UE goes idle? (Choose 2)
- Question #87
Which of the following most accurately identifies a GTP tunnel on the Alcatel-Lucent 7750 MG by default?
- Question #88
Which of the following statements is TRUE when a UE is in the EMM_DEREGISTERED/ECM_IDLE state?
- Question #89
Which of the following most accurately describes the messages used to manage a Diameter connection path?
- Question #90
Based on the information shown in the exhibit, when the SGW receives an IP packet from the UE, which of the following is the GTP TEID value expected to be received in the GTP packe...
- Question #91
Which of the following is used to carry the GTP Path Management message "Echo Request"?
- Question #92
Which of the following statements is FALSE regarding the PGW?
- Question #93
Which of the following statements are FALSE regarding the SDF templates / filters? (Choose two)
- Question #94
In a 3G network, which of the following statements most accurately describes the user data plane between a UE and the GGSN when a direct tunnel is not used?
- Question #95
The S1-MME is the interface used for the communication between the eNodeB and the MME. Which of the following transport protocols is used by this interface?
- Question #96
On Alcatel-Lucent 7750 PGW, which of the following CLI commands can be used to debug a given IMSI?
- Question #97
Based on the information shown in the exhibit, how many mobile subscribers is the PGW currently serving?
- Question #98
Which network entities assign TEIDs to the indirect data tunnel used during an S1-based handover with SGW relocation?
- Question #99
Which of the following statements is FALSE regarding the SGW handling of an incoming GTP packet with a TEID value of zero?
- Question #100
Which of the following statements is FALSE regarding the support of MG-ISM redundancy on an Alcatel-Lucent 7750 MG?
- Question #101
Which of the following statements is FALSE regarding the QCI / ARP?
- Question #102
Which of the following statements most accurately describes the MME?
- Question #103
When MG-ISM redundancy is used on an Alcatel-Lucent 7750 MG, which of the following statements is FALSE?
- Question #104
On Alcatel-Lucent 7750 SGW, which of the following CLI commands is used to obtain the output displayed in the exhibit?