4A0-C01 Exam Questions
783 real 4A0-C01 exam questions with expert-verified answers and explanations. Page 13 of 16.
- Question #656
A router has two admin groups defined (GREEN=1 and RED=3). An interface is associated to both admin groups. What value will be shown in the Admin Group sub-TLV for this interface?
- Question #657
A service can be either local or distributed.
- Question #659
Which of the following statements is FALSE regarding 6VPE?
- Question #660
Click on the exhibit. Why might router R2 have a Link LDP session to R1 (10.10.10.1:0) but not to R3 (10.10.10.3:0)?
- Question #661
Which of the following is NOT required to configure an Alcatel-Lucent 7750 SR as a PE router running 6PE?
- Question #662
Click on the exhibit. Given the output below, which of the following is FALSE?
- Question #663
Click the exhibit. Assuming CE1 exports its system address using BGP, is a routing policy required on PE1 to advertise CE1's system address to PE2?
- Question #664
Which of the following about the Isp-ping command on the Alcatel-Lucent 7750 SR is FALSE?
- Question #666
Which of the following about IES is FALSE?
- Question #667
A VPLS receives a frame with the single VLAN tag 35 on the Q-in-Q SAP 1/1/1:35.*. Which of the following describes default Alcatel-Lucent 7750 SR behavior?
- Question #668
Which of the following best describes a local Epipe Service?
- Question #669
Click the exhibit. The two PEs are providing 6VPE and IPv4 VPRNs. The core network is IPv4/MPLS. Which of the following is the BGP family configuration for the MP-BPG on the PEs?
- Question #670
Which of the following about the Alcatel-Lucent 7750 SR's sdp-ping utility is FALSE?
- Question #671
By default, what happens when a packet with a VLAN tag is received on a SAP provisioned with null encapsulation?
- Question #673
Click the exhibit. Which tool produced this output?
- Question #674
Consider an E-pipe service configured with SAP 1/1/1:5 and SAP 1/1/1:6. If the SAP 1/1/1:5 accepts an ingress frame, which of the following is TRUE?
- Question #675
Which of the following about 6VPE is FALSE?
- Question #676
A network consists of four PE routers. A customer requires a VPLS and has sites connected to each PE. The VPLS is fully meshed using IP/MPLS. How many SDPs must be configured on ea...
- Question #677
Which service type is needed to bridge an ATM-attached user and an Ethernet-attached user?
- Question #678
A customer requests that their Layer 2 Ethernet service be configured to forward frames up to 1514 bytes. The service provider is using MPLS encapsulation and RSVP-TE fast- reroute...
- Question #680
A network technician needs to set up a local mirror to replicate traffic for examination with a protocol analyzer. The analyzer is on port 1/1/4 of his service router. Which of the...
- Question #681
A CE is connected to an IES interface. Which of the following is TRUE?
- Question #682
Consider a network that has four PE routers. If a customer wants a VPLS that has sites on only three of the PEs, how many mesh SDPs need to be configured for this service?
- Question #683
Service tunnels and transport tunnels are bidirectional and only require the operator to configure the tunnel on one router.
- Question #684
Which of the following regarding 6VPE is FALSE?
- Question #685
Which protocol is used to signal the inner label for a L2-VPN service?
- Question #686
On an Alcatel-Lucent 7750 SR, what is the recommended approach for making sure that MTUs between a VPLS and its spoke IES termination match?
- Question #688
Click the exhibit. Based on this output from PE router R1, how many other PEs are participating in the VPRN?
- Question #689
Which of the following about SDPs is FALSE?
- Question #690
What happens by default on an Alcatel-Lucent 7750 SR when a null encapsulated SAP receives a frame with a VLAN tag?
- Question #691
Which of the following best describes how a MAC FDB is populated in a VPLS service?
- Question #692
Which utility on the Alcatel-Lucent 7750 SR can be used to investigate an MPLS path?
- Question #693
A Cpipe supports both structured and unstructured frames.
- Question #694
On an Alcatel-Lucent 7750 SR, which of the following statements about the default advertisement of VRF routes is true?
- Question #695
What command syntax would be used to create a new routed interface on an existing IES service?
- Question #696
Which of the following about VPRNs is FALSE?
- Question #697
The SAP 1/1/1:2.3 receives an untagged Ethernet frame. Which of the following is TRUE?
- Question #698
Click the exhibit. The operator at PE1 wants to analyze the traffic between CE4 and PE2. On an Alcatel- Lucent 7750 SR, which of the following is required as part of the configurat...
- Question #699
Click the exhibit. Which tool produced this output?
- Question #700
Which of the following statements about VPRN is NOT true? (Choose 2)
- Question #701
Which of the following must be configured when configuring an Epipe service? (Choose 4)
- Question #702
On an Alcatel-Lucent 7750 SR, the OAM command 'svc-ping' can be used with options bcal-sdp' and 'remote-sdp'. Which of the following is TRUE?
- Question #703
Which of the following about ADSPEC is FALSE?
- Question #704
Which of the following about an E-pipe terminating on a VPLS is FALSE?
- Question #705
Which of the following about SDPs is FALSE?
- Question #706
What Alcatel-Lucent 7750 SR OAM tool can be used to verify the end-to-end connectivity of a service?
- Question #707
An E-pipe is configured with a service MTU of 5000. What MTU value should be set on the access port for a Q-in-Q encapsulated SAP?
- Question #708
In a Layer 2 VPN service, the FCS is stripped when a customer packet arrives at the ingress PE and regenerated on egress.
- Question #709
Which of the following about SDPs is TRUE?
- Question #710
Which of the following SAPs will toward tagged frames but NOT untagged frames?