Nokia
4A0-105 · Question #88
Why should you configure send-flush-on failure on your PE routers when using active/standby pseudowires?
The correct answer is C. On failure, the PE sends an LDP flush-all-from-me message to all PE devices in the VPLS. This. See the full explanation below for the reasoning.
Question
Why should you configure send-flush-on failure on your PE routers when using active/standby pseudowires?
Options
- AIt flushes the local FDB speeding recovery
- BIt discards all packets in the queue and sends icmp-discad messages to the sender. The packets
- COn failure, the PE sends an LDP flush-all-from-me message to all PE devices in the VPLS. This
- DIt is not important to use send-flush-on-failure as Active/Standby signalling automatically
How the community answered
(22 responses)- A5% (1)
- B5% (1)
- C82% (18)
- D9% (2)
Community Discussion
No community discussion yet for this question.