4A0-104 Exam Questions
298 real 4A0-104 exam questions with expert-verified answers and explanations. Page 6 of 6.
- Question #253
Which of the following about the Isp-ping command on the Alcatel-Lucent 7750 SR is FALSE?
- Question #254
On an Alcatel-Lucent 7750 SR, what is the recommended approach for making sure that MTUs between a VPLS and its spoke IES termination match?
- Question #255
Which of the following best completes the sentence: "An Internet Enhanced Service is a_____________ service where the CE communicates with a ________________interface to send and r...
- Question #256
What does a PE do when a frame is received in a VPLS service with an unknown destination address by default?
- Question #257
What are the two major differences between configuring an IES service and configuring VPWS or VPLS services? (Choose 2)
- Question #258
Which of the following statements is FALSE regarding SAPs?
- Question #259
Which of the following most accurately describes the default behavior of a VPLS regarding the handling of a tagged frame at the ingress ofSAP1/1/1:100?
- Question #260
A customer requests that their Layer 2 Ethernet service be configured to forward frames up to 9000 bytes. The service provider is using MPLS encapsulation. What is the minimum MTU...
- Question #261
Which OAM command can be used to verify the correct and consistent provisioning of a service between two service end points?
- Question #262
Which of the following statements are TRUE regarding a fully meshed VPLS service with a default setting? (Choose 3)
- Question #263
Which of the following is NOT a VPWS service supported on the Alcatel-Lucent 7750 SR?
- Question #264
Which of the following options are used to configure an MPLS signaling type to be used on an SDP? (Choose 2)
- Question #265
Which of the following statements are TRUE about configuring a SDP between an IES and a VPLS? (Choose 2)
- Question #266
How many service labels must be signaled to bring up a fully meshed VPLS service among four PE routers?
- Question #267
Click on the exhibit button below. Is a routing policy required on PE1 to advertise a CE1's system interface to PE2?
- Question #268
What distinguishes a VPLS service from a VPWS service?
- Question #269
Which of the following statements best describes the purpose of an MP-BGP in a VPRN?
- Question #270
By default, what does an Alcatel-Lucent 7750 SR do to support VPLS services for different customers?
- Question #271
Which of the following SAP encapsulations does NOT support multiple services on a port?
- Question #272
A customer requests that their Layer 2 Ethernet service be configured to forward frames up to 1514 bytes. The service provider is using MPLS encapsulation and RSVP-TE fast- reroute...
- Question #273
Why must the MTU be changed when configuring an IES spoke termination to a VPLS?
- Question #274
Click the exhibit. Which OAM tool produced this output?
- Question #275
Consider a network that has four PE routers. If a customer wants a VPLS that has sites on only three of the PEs, how many mesh SDPs need to be configured for this service?
- Question #276
Which of the following best describes an SDP?
- Question #277
An E-pipe is configured with a service MTU of 5000.What value will be derived for the VC- MTU?
- Question #278
Which one of the following items CANNOT be used as a mirror source on an Alcatel-Lucent 7750 SR?
- Question #279
What happens when a packet without a VLAN tag is received on a SAP provisioned with null encapsulation while an SDP vc-type is provisioned as vlan?
- Question #280
What is the default vc-type for an SDP on the Alcatel-Lucent 7750 SR?
- Question #281
In a Layer 2 encapsulation, using Martini, what does the second (bottom) label represent?
- Question #282
Which of the following commands is used to enable an Epipe service?
- Question #283
Which of the following are characteristics of a SDP? (Choose 2)
- Question #284
What command syntax would be used to create a new IES service with a service id of 5 and a customer id of 1000?
- Question #285
Which of the following SAPs willforward tagged frames with an outer VLAN tag of 200? (Choose 3)
- Question #286
Which service type would be used to provide a bi-directional Layer 2 connection of TDM circuits over an IP/MPLS network?
- Question #287
Once a service has been created with a customer association, it is possible to change the customer association.
- Question #288
Which of the following must be configured when configuring an Epipe service? (Choose 4)
- Question #289
Point to multipoint MPLS Layer 2 VPN connectivity and encapsulation is described most accurately by which of the following?
- Question #290
True or False? Nodes that are not directly connected by a physical link cannot participate in a VPN
- Question #291
Which of the following SAP encapsulations supports only a single service on a port?
- Question #292
Which of the following statements is true?
- Question #293
True or False? There can only be one SAP per access port?
- Question #294
Which of the following services does not make use of an SDP? (Choose all that apply)
- Question #295
Fill in the blank for this next sentence. Flooded traffic received on a ______________is replicated on all other "ports" (other spoke SDP, mesh SDPs or SAPs) and not transmitted on...
- Question #296
Which of the following describes an access port configured with Dot1q encapsulation?
- Question #297
Which of the following components must be configured on a PE participating in a distributed Epipe service? (Choose 3)
- Question #298
Which of the following frame encapsulation types require the PE to perform SAR before sending the frame across the pseudowire?
- Question #299
Which of the following is not an Alcatel implementation of VPWS? (choose all that apply)
- Question #300
Which of the following is not required for establishing a distributed VPWS using MPLS as the transport?