3605 Exam Questions

A technician is configuring an InterSwitch Frank (IST) for Spilt Multi-Link Franking (SMLT). Which statement about how the IST is addressed is true?

What is the underlying dynamic link state routing protocol used for the implementation of the Avaya Enterprise Fabric?

By default the ERS 8000 is configured for warm standby. After installation of a new ERS solution with dual CPUs, which three actions need to be Perform on the ERS configuration to...

The Ethernet Routing Switch (ERS) 8600 switch includes a means to fine tune the memory resources by allowing the record allocations to be allowed. An ERS 8600 running Release 5.0 n...

Avaya 3605 Exam In a unified access solution that supports mobility, the configuration must allow for the creation of mobility tunnels to the remote switch and needs the reservatio...

In a multicast campus, when should an ERS 8600 PIM interface be configured to run in passive mode?

A split Multi-Link Trunking (SMLT) for switch clustering is being configured. Which statement is a configuring requirement for the SMLT?

Which feature should be configured to limit which ports receive multicast streams?

On the Ethernet Routing Switch (ERS) 8800, the Virtual Routing Forwarding (VRF)-Lite feature supports multicast virtualization. Which statements about multicast virtualization are...

Refer to the exhibit. Virtual Link Aggregation Control Protocol (VLACP) is configured by port, and traffic is only forwarded across the uplinks when VLCAP is up and running correct...

Which statement describes the specific mechanism available for managing the switch using a common IP address, regardless of which CPU is the primary?

Which types of topologies are supported in the implementation of the Avaya Enterprise Fabric? (Choose three)

Simple Loop Prevention Protocol (SLPP) detects VLAN based network loops. Which two statements about SLPP functionality are correct? (Choose two.)

An Ethernet Routing Switch (ERS) 8600 is being configured for Virtual Router Redundancy Protocol (VRRP). If the default value is used on the peer switch, which CLI command would ca...

A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Ethernet Routing Switch (ERS) 8000-based core. The technician has to configure VRF...

During the installation of the unified access solution, the IP address of the wireless switch interface needs to be configured on the ERS 8000. Which IP address must be used in the...

During the installation of a unified access solution, the IP address of the wireless switch interface needs to be configured on the ERS 8000. Which IP address must be used in confi...

Routed Split Multi-Link Trunking (RSMLT) is a way to ensure that traffic can be routed off the VLAN by adding router redundancy. When configuring the Ethernet Routing Switch (ERS)...

A customer has security concerns with the current RADIUS authentication implementation and is asking to change all authentication requests from the ERS 8000 to be directed to their...

Avaya 3605 Exam Before enabling IP Source through Device Manager, which two conditions must be met on the system?

IPFIX protocol used for the export of flow information from traffic observed on a switch. Which three statements are true for the functioning of the IPIX protocol? (Choose three)

After issuing a show ist stats (CLI) or show ist stat (ACLI) command, it is determined that the running type is normal MLT and not inter Switch Trunks? (Choose two)

While troubleshooting a MultiLink Trunking (MLT) and split MultiLink Trunking (SMLT) network a need arises to determine which link packets are traversing. Which feature should be u...

The IEEE 802.1aq virtualized service standard supports two modes of operation for the implementation of shortest path Bridging. Which mode is supported in the Avaya VENA Enterprise...

When Incorporating Split Multi-Link Trunk (SMLT) on a pair of Ethernet Routing Switch (ERS) 8600 switches traffic from the edge of the network is directed to either ERS 8600. The p...

Refer to the exhibit. Which commands will configure the labeled Ethernet ports shown in the exhibit correctly?

The configuration on an ERS 8000 contains a static route, the output from a show ip route info (CLI) command or the routing table output on EDM does not display the destination net...

A technician is setting up switch clustering using Split Multi-Link Trunking (SMLT). Which link is configured between the SMLT cluster switches?

OSPF computes the shortest path to destination subnets, whereas, IS-IS, as used with SPBM works differently. Which parameter does IS-IS use to compute the path?

When configuring an Ethernet Routing Switch (ERS) 8000 redundant installation for warm standby, which protocol is used to give the fastest recalculation of a large layer 3 topology...

For a Converged campus network, which configuration changes is recommended for the default VLAN (VLAN 1)

When configuring an Ethernet Routing Switch (ERS) 8000 split Multi-Link Trunking (SMLT), protection against an edge switch in the factory default condition must be taken into consi...

When configuring link aggregation, a technician created a Distributed Multi-Link Trunk (DMLT) group on the Edge switch to the switch cluster core. What gets distributed?

When configuring LINK aggregation, a technician created a Distributed Multi- Link Trunk (DMLT) group on the edge connecting switch cluster core. What gets distributed?

What is a characteristic of Routed Split Multi-Link Trunking (RSMLT) configuration?

Avaya 3605 Exam To provide load distribution across two or more equal cost paths in a Layer 3 routing environment, the ECMP feature can be used to maximize load sharing. Which two...

A university campus network consists of an Ethernet Routing Switch (ERS) 8000 and Ethernet switches. Recently they implemented Routed Split Multi-Link Trunking (RSMLT) over a split...

A switch with Simple Loop Prevention Protocol (SLPP) did not detect a loop. What are two reasons this occurred? (Choose two.)

Which protocol can be used for end-to-end detection in a network as well as for point-to-point detection?

Refer to the exhibit. A campus network has been established with four Ethernet Routing Switch (ERS) 8600 switches in a switch cluster, two pairs with an Inter Switch Trunks (IST) r...

Which statement describes a step in provisioning SPBM in an enterprise network?

Which VLAN/VLANs should be included on the Inter Switch Trunks (IST) for a proper functioning split Multi-Link (SMLT) configuration?

A technician wants to control the routes being added to the routing table from the BGP routing table. Which statement describes how to do this?

When multiple VLANs are used, Dynamic Host Control Protocol (DHCP) relay is required to get the DHCP information from the end user VLAN DHCP server. Which statement about how to en...

Which feature can be used on Split Multi-Link Franking (SMLT) with a SoftDown option?

You are configuring a QoS Policy on an ERS RS or 8800 module to police the ingress data rate on a port with the following ACLI command on the interface level: qos if-policer police...

To confirm that routed split Multi-Link Trunking (RSMLT0 will work on a set of VLANs, which network design aspect should be considered?

A technician is configuring 802.1Q tagging, Virtual Link Aggregation Control Protocol (VLACP) with short timeout, and untagged frames to be discarded. Which part of the network is...

A customer has implemented an ERS 8000 solution and deployed the configuration and Orchestration Manager (COM). Which tool from within COM is used to set up and manage spanning tre...

When configuring Single Link Trunking (SLT) or Split Multi-Link Trunking (SMLT), what can be done to facilitate easily adding more VLANs to the network without impacting traffic?