3600 Exam Questions

Auto-negotiation should be enabled on all ports except under which condition?

When configuring an Ethernet Routing switch (ERS) 8600 for Split Multi-Link Trunking (SMLT), protection against an edge switch in the factory default condition must be taken into c...

A technician is configuring the core of a Converged Campus network, and is adding a backup- master configuration to an existing Virtual Router Redundancy Protocol (VRRP) configurat...

In the interaction between EAPO17802.1 and the Enterprise Policy Manager (EPM), what is the role EPM in the User-Based Policy (UBP) process?

A technician wants to control the routes being added to the routing table from the BGP routing table. Which statement describes how to do this?

When checking an Inter Switch Trunks (1ST) configuration using the show mlt ist info command, which IP address should be in the IP ADDRESS column? Avaya 3600 Exam

In a multicast campus, when should the PIM interface in passive mode be configured?

A split Multi-Link Trunking (SMLT) for switch clustering is being configured. Which statement is a configuration requirement for the SMLT?

Avaya 3600 Exam After issuing a show mit ist stats (CLI) or show ist stat (ACLI) command, it is determined that running type is normal MLT and not Inter Switch Trunks (IST). Which...

Consider the following port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module: Left LED - green Right LED - flashing green What is the status...

The attempt to manage an Ethernet Routing switch (ERS) 8600 using a Virtual Router Redundancy protocol (VRRP) address was unsuccessful. What is causing this problem?

A technician is configuring password levels on the Ethernet Routing Switch (ERS) 8600, and wants the manager to be able to view and edit device settings, but not to be able to chan...

After experiencing issues with XFPs, the show sys pluggable-optical-modules info CLI command is used to find that the switch does not recognize the XFPs. Which other method can be...

An Ethernet Routing Switch (ERS) 8600 is being configured for Virtual Router Redundancy Protocol (VRRP). If the default value is used on the peer switch, which CLI command would ca...

A technician wants to use the New Unit Quick Configuration feature to add new units to a stack of Ethernet Routing Switch (ERS) 5000 switches without. As well as enabling the featu...

As stated in RFC 2338. (Virtual Router Redundancy Protocol) VRRP management problems can occur if the address used by the management station is used incorrectly. Which two statemen...

A technician is configuring 802.1 Q tagging, VLACP with short timeout, untagged frames to be discarded. Which part of the network is being configured?

Where is the rate-limit feature of the Converged Campus architecture limited?

A technician is implementing a new network that contains eight Ethernet routing switch (ERS) 8600 switches and uses advanced features. Where are two possibilities for generating li...

Consider the following deployment requirements: - Support 40 100 Mb/s VoIP telephones, each with a power requirement of 6 Watt - Support 40 directly connected 1000 Mb/s Ethernet wo...

During a power-on or cold-start sequence, at which stage can he flags to change the operational environment of the switch be set?

Ethernet Routing Switch (ERS) 5500 supports a resilient stacking architecture using FAST Stack technology with this stacking capability, what is the total stacking bandwidth for a...

With release 4.0 or higher software on the Ethernet routing switch (ERS) 8300, an advanced routing license is required to enable certain features. Which two statements ant true abo...

Consider the fallowing port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module left LED -green Right LED - flashing green. What is the status o...

Click on the exhibit button. After checking the VLAN configuration using the show vlan info basic and the show vlan info port commands, there are no ACTIVE MEMBER ports for VLM4-50...

A network has some Ethernet Routing Switch (ERS) 5500 switches licensed at the advanced level for Release 6 2 A technician implementing Protocol independent Multicast - Sparse Mode...

Which two pairs of commands will configure spanning tree on the edge switch? (Choose two)

An Ethernet routing switch (ERS) 4550T-PWR has been deployed with a single AC power supply and is currently supporting 20 VoIP telephones with power over Ethernet (PoE). each with...

Which steps are initial steps required to configure the Ethernet Routing Switch (ERS) 8600 in a clustered basic core configuration? (Choose three.)

An Ethernet Routing Switch (ERS) 8600 for Virtual Router Redundancy Protocol (VRRP) is being configured. Which CU command would cause this switch to be the VRRP master?

A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 lo a core pair of ERS 8600 switches. Which statement about the correct...

After issuing a show mlt list stats (CLI) or show ist Stat (ACLI) command, it is determined that the running type is normal MLT and not 1ST What are two causes of the IST not runni...

A customer has purchased some Ethernet Routing Switch (ERS) 5600 switches must integrate two ERS 5600 units into existing stack of ERS 5500 switches. What is the procedure for the...

What is the maximum number of Gigabit Ethernet ports on a single Ethernet Routing Switch (ERS) 8300 Input/Output module?

Consider four software upgrade events on an Ethernet Routing Switch (ERS) 2500 series switch: Avaya 3600 Exam 1. Upgrade the software image 2. The System Reboots 3. Backup the bina...

Avaya recommends using RSMLT edge in place of VRRP with Backup Master, when available what are two valid reasons for using RSMLT edge? (Chouse two)

A technician has complied me configuration of an Ethernet Routing (ERS) 5520 to and now must transfer a backup copy of configuration file to server. Which command is used to accomp...

A technician has implemented RSMLT edge design. After recovering from power outage some clients could not communicate. It has been stated that only one of the core RSMLT switches h...

The attempt to manage an Ethernet Routing Switch (ERS) 8600 using a VRRP address was unsuccessful. What is causing this problem?

A technician is adding the Virtual Link Aggregation Control Protocol (VLACP) configuration ID a Converged Campus Solution where all Ethernet Routing switches (ERSs) are directly co...

A technician has installed a license file on the Ethernet routing switch (ERS) 8800 and rebooted, but cannot configure the associated licensed features. it has been determined that...

In a newly installed network the port LED on an Ethernet Routing Switch (ERS) 5500 is amber, not green. What does this mean?

The Ethernet routing switch (ERS) 5000 switches are being upgraded and it appears that a license is not recognized on the switch. Which two statements are valid sources of informat...

One of the switches in the Ethernet Routing Switch (ERS) stacks files and is replaced. The auto unit replacement (AUR) is enabled but the stack is not functioning properly. What is...

A technician needs to reboot an Ethernet Routing Switch (ERS) 5000 Series switch with a default configuration. What needs to be done to keep the IP address and stack license?

A split multi link trunking (SMLT) for switch clustering is being configured. Which statement is a configuration requirement for the SMLT?

A customer needs to install a new Ethernet Routing Switch (ERS) 2550T on the 172.16.5.0/24 network, but does not have a console cable available. Which statement is correct?

Click the exhibit button. SLPP has just been enabled on both core switches. Based on the network diagram and console output from the core 1 Ethernet Routing Switch (ERS) B600 shown...

A technician is configuring password levels on the Ethernet Routing Switch (ERS) 8600, and wants the manager to be able to view and edit most device settings, but not be able to ch...

Routed Split Multilinking Trunking (RSMLT) is a way to ensure that traffic can be routed off the VLAN by adding router redundancy. RSMLT is configured on which Ethernet Routing Swi...