An engineer must configure a dial plan for a new Cisco UCM cluster. Standard local route groups must be used for all local calls. After the route pattern, route list, and route groups are…

Question

Options

• Adevice pool
• Btrunk group
• Cvoice gateway
• DSIP trunk

• A
  70% (23)
• B
  6% (2)
• C
  18% (6)
• D
  6% (2)

Explanation

In Cisco Unified Communications Manager (UCM), Standard Local Route Groups allow dynamic routing decisions based on the device pool assigned to the originating device. The device pool is the critical configuration that specifies the local route group to be used for routing calls. This eliminates the need for static route patterns for each site, simplifying the dial plan and increasing 1. Configure Standard Local Route Group in Device Pool: - Go to System > Device Pool in the UCM Administration interface. - Select the appropriate device pool for the devices that will use the standard local route group. - Assign the Standard Local Route Group in the "Local Route Group" field. 2. Dynamic Routing via Device Pools: - When a call matches a route pattern configured to use Standard Local Route Group, the system dynamically selects the appropriate route group based on the calling device's assigned device

No community discussion yet for this question.