An administrator must configure the local route group feature on cisco UCM. Which step will enable this feature?

Question

Options

• AFor each route list configure a route group to use as a Local Route Group.
• BFor each route pattern, select the Local Route Group as the destination.
• CFor each route group, check the box for the Local Route Group feature.
• DFor each device pool, configure a route group to use as a Local Route Group for that device pool

• A
  3% (1)
• B
  3% (1)
• C
  5% (2)
• D
  90% (36)

Explanation

The Local Route Group (LRG) feature in Cisco UCM enables dynamic, location-aware call routing. The mechanism works as follows: (1) A route group is assigned as the 'Local Route Group' in each device pool, representing the gateway local to that site. (2) Route lists reference the 'Standard Local Route Group' as a route group placeholder. (3) When a call is placed, UCM looks up the calling device's device pool and dynamically substitutes the actual route group configured there for 'Standard Local Route Group.' This allows a single route pattern and route list to serve multiple sites, with each site's calls automatically egressing through its own local gateway - all controlled by the device pool configuration.

No community discussion yet for this question.