A storage engineer must configure Cisco TrustSec Fibre Channel by using manual ESP mode on a Cisco MDS 9000 Series Switch. ESP mode must use the default message authentication and encryption method…

Question

Options

• AMDS-01(config)# interface fc 1/11
• BMDS-01(config)# interface fc 1/11
• CMDS-01(config)# interface fc 1/11
• DMDS-01(config)# interface fc 1/11

• A
  82% (32)
• B
  3% (1)
• C
  5% (2)
• D
  10% (4)

Explanation

The command fcsp esp manual on the interface enables Cisco TrustSec Fibre Channel in manual ESP mode with the default authentication (GMAC) and encryption (AES-GCM) settings. No additional mode configuration is required for the default. Exam Questions, Study Guides, Practice Tests. Lead the way to help you pass any IT Certification exams, 100% Pass Guaranteed or Full Refund. Especially Cisco, Microsoft, CompTIA, Citrix, EMC, HP, Oracle, VMware, Juniper, Check Point, LPI, Nortel, EXIN and so on. Our Slogan: First Test, First Pass. Help you to pass any IT Certification exams at the first try. You can reach us at any of the email addresses listed below. Any problems about IT certification or our products, you could rely upon us, we will give you satisfactory answers in 24 hours.

No community discussion yet for this question.