Cisco
350-050 · Question #352
You install an autonomous AP using the default dot11 radio parameters. After the installation, you notice that the wireless network performance is degraded severely while the microwave oven in the…
The correct answer is B. Statically configure the AP to use channel 1. See the full explanation below for the reasoning.
Question
You install an autonomous AP using the default dot11 radio parameters. After the installation, you notice that the wireless network performance is degraded severely while the microwave oven in the cafeteria is in use. The microwave oven uses the higher 2.4-GHz channels. How can you solve the issue?
Options
- AIncrease the transmit power of the access point radio.
- BStatically configure the AP to use channel 1.
- CEnable RRM on the AP.
- DIf DFS is enabled on the AP, reset the radio.
How the community answered
(27 responses)- A7% (2)
- B74% (20)
- C4% (1)
- D15% (4)
Community Discussion
No community discussion yet for this question.