Cisco
350-050 · Question #275
Refer to the exhibit. A network administrator is configuring and installing an indoor mesh network using two CAPWAP APs. The APs were out of the box and have already been installed in their…
The correct answer is A. The MAP should have been primed to the WLC before being deployed. See the full explanation below for the reasoning.
Question
Refer to the exhibit. A network administrator is configuring and installing an indoor mesh network using two CAPWAP APs. The APs were out of the box and have already been installed in their designated locations. The RAP is joined to the controller and configured appropriately, but the MAP is not visible on the WLC. In the output shown, which of these explanations is the most likely reason for the issue?
Exhibit
Options
- AThe MAP should have been primed to the WLC before being deployed.
- BThe MAP should have been primed to the WLC before being deployed.
- CThe MAP does not have to be primed to the WLC before being deployed to the field because the
- DThe MAP should have been primed to the WLC before being deployed.
- EThe MAP does not have to be primed to the WLC before being deployed.
How the community answered
(24 responses)- A75% (18)
- B4% (1)
- C4% (1)
- E17% (4)
Community Discussion
No community discussion yet for this question.