Cisco
350-040 · Question #261
When does a FCIP Interface need to be configured as B-Port?
The correct answer is C. When the other end of the FCIP link is a PA-FC-1G module on a 7200/7400 series. See the full explanation below for the reasoning.
Question
When does a FCIP Interface need to be configured as B-Port?
Options
- AThere are no practical reasons to configure the FCIP interface as a B-Port instead of an E-Port.
- BB-Port does not apply to FCIP interfaces because it is a mode that needs to be configured if an interface
- CWhen the other end of the FCIP link is a PA-FC-1G module on a 7200/7400 series
- DA FCIP link, as defined in the FC-BB (Fibre Channel Backbone) standard, is always configured as B-Port,
- EB-Port is the way the FCIP interface needs to be configured if the source GigEthernet interface is connected
How the community answered
(21 responses)- A5% (1)
- B5% (1)
- C76% (16)
- D14% (3)
Community Discussion
No community discussion yet for this question.