350-029 Exam Questions
524 real 350-029 exam questions with expert-verified answers and explanations. Page 2 of 11.
- Question #52
What is the port number of an IPsec Encapsulating Security Payload packet?
- Question #53
Which MQC-based output queueing method is designed to support multiple traffic classes including VoIP traffic, mission-critical traffic, bulk traffic, interactive traffic and defau...
- Question #54
Which two statements regarding the IS-IS DIS election process are true? (Choose Two.)
- Question #55
What is jitter?
- Question #56
Which two statements best describe the signalling requirements of virtual circuit setup of VPLS and exchange of reachability information (MAC addresses)?
- Question #57
What bit should be set in the link state PDUs in an IS-IS level-1-2 router to indicate that they are a potential exit point out of the area ?
- Question #58
Select the two answers that best describe the IP Event Dampening feature:
- Question #59
What OSPF LSA is used to support MPLS-traffic Engineering ?
- Question #60
Select the three best answers which best describe Private Network-to Network Interface (PNNI) in an ATM network
- Question #61
With EIGRP DUAL, a feasible successor is considered loop-free if which condition is true?
- Question #62
What best describes the usage of Route-Target rewrite?
- Question #63
Which three attribute-value pairs (AVPs) must be present in L2TPv3 ICRQ messages? (Choose three.)
- Question #64
Which descriptions of Netflow is correct?
- Question #65
How do routers in an IS-IS Level-1 domain exit to reach other Level-1 (L1) domains ?(Select 2)
- Question #66
DSCP value "101110" looks like which IP Precedence value to non-DiffServ compliant devices?
- Question #67
Which two statements are true about SAFI & AFI?
- Question #68
Having the above BGP peerings, select the two configurations for rtrB that will fulfill the following criteria: -Will advertise all routes from rtrA to rtrD but not to rtrC -Will a...
- Question #69
Selective packet discard(SPD)operates in the following modes: (choose3)
- Question #70
Which of the following processes in IOS XR run exclusively on the Route Processor?
- Question #71
The Attribute field within the IS-IS LSP header contains which of the following flags? (Choose four)
- Question #72
What protocol is used for Path Setup in MPLS traffic engineering?
- Question #73
Which of the following comparison of Control Plane Policing (CoPP) with Receive ACL(Racl) is correct?
- Question #74
What best describes the usage of Route-Target rewrite?
- Question #75
Which of the following are steps to configure destination-based Remote Triggered Black Hole(RTBH) filtering?(choose three)
- Question #76
Based on the following output in a router A running LDP, which statement is true? show mpls ldp bindings 50.0.0.1 32 tib entry: 50.0.0.1/32, rev 5 local binding: tag: imp-null remo...
- Question #77
According to RFC 3931,L2TPv3 utilizes the IANA assigned IP protocol ID of:
- Question #78
When IPv6 is deployed by a Service Provider to bring on an IPv6 Enterprise, which transition strategy works the best?
- Question #79
With VPLS, which protocol is used for label exchange and PW signalling.
- Question #80
Refer to the exhibit. Your customer has enabled IPv6 and IPv4 on routers R1 and R2, both running ISIS routing protocol, and they can no longer reach R3 network 172.26.15.0/24 (R3 d...
- Question #81
Which methods would enable traffic to be forwarded along an MPLS TE tunnel (Choose 4)
- Question #82
Which of the following descriptions about IP spoofing is correct?
- Question #83
SONET's three layers are: (Choose three.)
- Question #84
With the DSCP value fo "101110", what does the "11" in bits 1 and 2 indicate ?
- Question #85
What are the benefits of using TCAM technology in high-end routing products ?
- Question #86
Referring to the exhibit, if RTP header compression is used on the link, the header??s overhead on the voice packet will be reduced by what percent?
- Question #87
Which two statements are correct?
- Question #88
Which of the following technologies can improve convergence time following a link failure in a service provider network? (Choose two.)
- Question #89
Which of the following statemets regarding Control Plane Policing (CoPP) is correct?
- Question #90
Which two statements are correct with regard to route distinguisher as defined in RFC 4364-AKA IP-VPN(MPLS-VPN)?
- Question #91
Which two statements are true about DPT/RPR?
- Question #92
Which statements about MPLS Label Distribution Protocol(LDP) are valid?
- Question #93
How would you characterize the source and type in a denial of service attack on a router?
- Question #94
Which of the following IOS commands cause syslog messages to be stamped with time and dates?
- Question #95
In the context of GMPLS,LMP stands for;
- Question #96
Which of the following statements is correct regarding PIM Sparse Mode operations?
- Question #97
Which statements are correct for forwarding traffic into MPLS TE tunnels? (Choose 3)
- Question #98
Select two valid administratively scoped multicast addresses in networks running Interior Gateway protocols like EIGRP and OSPF
- Question #99
In which of the following lists of APS Action Requests is the priority correctly arranged from lowest to highest?
- Question #100
What is the action of "pop" in the context of MPLS switching?
- Question #101
What is the encapsulation mode for MPLS running on Ethernet?