Cisco
350-029 · Question #492
Refer to the exhibit. R3 is not able to install the R1 loopback address into its BGP routing table. What should be configured toinstall that route?
The correct answer is D. Configure the next-hop-self command on R2. See the full explanation below for the reasoning.
Question
Refer to the exhibit. R3 is not able to install the R1 loopback address into its BGP routing table. What should be configured toinstall that route?
Exhibit
Options
- AConfigure R2 as a route reflector.
- BEnable EBGP multihop on R2.
- CChange the origin attribute to IGP on R3.
- DConfigure the next-hop-self command on R2.
- EConfigure the next-hop-unchanged command on R2.
- FAdd a static route toreach 10.10.23.2 on R3.
How the community answered
(32 responses)- A9% (3)
- B3% (1)
- C6% (2)
- D81% (26)
Community Discussion
No community discussion yet for this question.