F5
303 · Question #455
A BIG-IP Administrator creates a new VLAN on BIG-IP Cluster Member A and attaches an Interface to it. Although the Auto Config Sync is in place, the new VLAN does NOT show up on Cluster Member B…
The correct answer is A. Configure the new VLAN manually on Cluster Member B. See the full explanation below for the reasoning.
Question
A BIG-IP Administrator creates a new VLAN on BIG-IP Cluster Member A and attaches an Interface to it. Although the Auto Config Sync is in place, the new VLAN does NOT show up on Cluster Member B. What should the BIG-IP Administrator do to ensure the new VLAN is configured on each Cluster Member?
Options
- AConfigure the new VLAN manually on Cluster Member B.
- BReset the Device Trust of the BIG-IP Cluster on either Cluster Member.
- CConfigure a Default Route for the new VLAN on Cluster Member A.
- DEnable the Interface that is attached to the new VLAN on Cluster Member A.
How the community answered
(63 responses)- A83% (52)
- B10% (6)
- C5% (3)
- D3% (2)
Community Discussion
No community discussion yet for this question.