300-710 · Question #434
An engineer is configuring a Cisco Secure Firewall Threat Defense device to operate in transparent mode between two switch stacks. VLAN 10 is used for in-band management on both switch stacks. Which…
The correct answer is D. Configure a BVI interface for VLAN 10. E. Configure at least one bridge group. In transparent mode, a Cisco Secure Firewall Threat Defense (FTD) device must be configured - A Bridge Virtual Interface (BVI) for management access (e.g., VLAN 10) since it does not participate in IP routing. - At least one bridge group to enable traffic forwarding between…
Question
An engineer is configuring a Cisco Secure Firewall Threat Defense device to operate in transparent mode between two switch stacks. VLAN 10 is used for in-band management on both switch stacks. Which two actions are required on the device to inspect traffic between the two switch stacks without causing any interruption to network traffic? (Choose two.)
Options
- ASet the MTU to 9198 on all interfaces to support jumbo frames.
- BAdd separate routes for data and management traffic.
- CExempt BPDUs from advanced inspection
- DConfigure a BVI interface for VLAN 10.
- EConfigure at least one bridge group.
How the community answered
(26 responses)- A4% (1)
- B8% (2)
- C15% (4)
- D73% (19)
Explanation
In transparent mode, a Cisco Secure Firewall Threat Defense (FTD) device must be configured - A Bridge Virtual Interface (BVI) for management access (e.g., VLAN 10) since it does not participate in IP routing. - At least one bridge group to enable traffic forwarding between interfaces (i.e., the switch stacks), as transparent mode uses bridging at Layer 2 to inspect traffic. These two actions allow the device to inspect traffic without disrupting the Layer 2 forwarding behavior of the existing network.
Topics
Community Discussion
No community discussion yet for this question.