Refer to the exhibit. An engineer is configuring an instance of Cisco Secure Firewall Threat Defense with a Secure Firewall Threat Defense interface in IPS Inline Pair mode. What must the engineer…

The correct answer is B. propagate link state disabled. When configuring an Inline Pair mode as shown in the diagram (e1/6 as INSIDE and e1/8 as OUTSIDE), "propagate link state" must be disabled on the interfaces. This ensures that if one link goes down, the other interface doesn’t go down as well, which is important during…

Deployment

Question

Refer to the exhibit. An engineer is configuring an instance of Cisco Secure Firewall Threat Defense with a Secure Firewall Threat Defense interface in IPS Inline Pair mode. What must the engineer configure on interface e1/6?

Exhibit

Options

AFailSafe disabled
Bpropagate link state disabled
Cinline set MTU set to 1500
Dsecurity zone set to OUTSIDE_ZONE

How the community answered

(24 responses)

B
88% (21)
C
4% (1)
D
8% (2)

Explanation

When configuring an Inline Pair mode as shown in the diagram (e1/6 as INSIDE and e1/8 as OUTSIDE), "propagate link state" must be disabled on the interfaces. This ensures that if one link goes down, the other interface doesn’t go down as well, which is important during intrusion prevention testing or tuning.

Topics

#Cisco FTD#IPS Inline Pair#Interface Configuration#Link State Propagation

Community Discussion

No community discussion yet for this question.

Full 300-710 Practice