300-710 · Question #332
A network engineer must configure an existing firewall to have a NAT configuration. The new configuration must support more than two interfaces per context. The firewall has previously been…
The correct answer is A. Run the configure firewall routed command from the Secure FTD device CLI, and reregister with. To support more than two interfaces per context and enable NAT configurations, the firewall must operate in routed mode. Since the firewall was previously in transparent mode, the network engineer needs to change it to routed mode. Access the CLI of the Secure FTD device. Run…
Question
A network engineer must configure an existing firewall to have a NAT configuration. The new configuration must support more than two interfaces per context. The firewall has previously been operating in transparent mode. The Cisco Secure Firewall Threat Defense (FTD) device has been deregistered from Cisco Secure Firewall Management Center (FMC). Which set of configuration actions must the network engineer take next to meet the requirements?
Options
- ARun the configure firewall routed command from the Secure FTD device CLI, and reregister with
- BRun the configure manager add routed command from the Secure FMC CLI. and reregister with
- CRun the configure manager add routed command from the Secure FTD device CLI, and reregister
- DRun the configure firewall routed command from the Secure FMC CLI. and reregister with Secure
How the community answered
(20 responses)- A75% (15)
- B15% (3)
- C5% (1)
- D5% (1)
Explanation
To support more than two interfaces per context and enable NAT configurations, the firewall must operate in routed mode. Since the firewall was previously in transparent mode, the network engineer needs to change it to routed mode. Access the CLI of the Secure FTD device. Run the command configure firewall routed to switch the firewall from transparent mode to routed Reregister the FTD device with the FMC by running the configure manager add <FMC_IP> <Registration_Key> command from the FTD device CLI. This will ensure that the firewall can support the required NAT configurations and more than two interfaces per context.
Topics
Community Discussion
No community discussion yet for this question.