Cisco
300-615 · Question #94
Refer to the exhibit. An engineer must connect N2K-Fex-1 and N5K-Core-1 so that the traffic flow between the two devices uses load balancing. After inspecting the statistics of the interconnecting…
The correct answer is C. Configure the pinning max-link as 2. See the full explanation below for the reasoning.
Question
Refer to the exhibit. An engineer must connect N2K-Fex-1 and N5K-Core-1 so that the traffic flow between the two devices uses load balancing. After inspecting the statistics of the interconnecting interfaces, the engineer concludes that only one link is used. Which action resolves the problem?
Exhibits
Options
- AConfigure source-destination load balancing on N5K-Core-1.
- BConfigure each uplink to be a member of a separate LACP port channel.
- CConfigure the pinning max-link as 2.
- DConfigure destination-mac load balancing on N5K-Core-1
How the community answered
(34 responses)- A6% (2)
- B12% (4)
- C79% (27)
- D3% (1)
Community Discussion
No community discussion yet for this question.