300-425 · Question #203
A company is upgrading the wireless infrastructure and is in a state of transition. Some parts of the company's building still run on the legacy WLC. The new WLC is not located at the same site as…
The correct answer is A. mping mobility_peer_IP_address. The command mping sends mobility tunnels control messages to the mobility peer IPs to verify connectivity at the mobility control plane level between wireless LAN controllers. This is an established troubleshooting command to check if mobility control packets pass firewall…
Question
A company is upgrading the wireless infrastructure and is in a state of transition. Some parts of the company's building still run on the legacy WLC. The new WLC is not located at the same site as the legacy WLC. The company requires seamless client inter-controller roaming between the new WLC and the legacy WLC, with no disruptions. Both WLCs are separated by firewalls. Which troubleshooting command validates that the mobility control packets between the WLCs can be sent and received?
Options
- Amping mobility_peer_IP_address
- Bdebug mobility handoff enable
- Cdebug mobility config enable
- Deping mobility_peer_management_IP_address
How the community answered
(50 responses)- A76% (38)
- B14% (7)
- C4% (2)
- D6% (3)
Explanation
The command mping sends mobility tunnels control messages to the mobility peer IPs to verify connectivity at the mobility control plane level between wireless LAN controllers. This is an established troubleshooting command to check if mobility control packets pass firewall boundaries and are acknowledged by the peer WLC in mobility groups.
Topics
Community Discussion
No community discussion yet for this question.