Which two parameters are part of the Cisco APIC first time setup and must be configured? (Choose two )

Question

Options

• Athe fabric node vector configuration
• Bthe LLDP adjacency configuration
• Cthe out of-band management configuration
• Dthe cluster configuration
• Ethe APIC LLDP configuration

• A
  3% (1)
• B
  3% (1)
• C
  87% (26)
• E
  7% (2)

Explanation

The following is a sample of the initial setup dialog as displayed on the console: Cluster configuration ... Enter the fabric name [ACI Fabric1]: Enter the fabric ID (1-128) [1]: Enter the number of active controllers in the fabric (1-9) [3]: Enter the POD ID (1-9) [1]: Is this a standby controller? [NO]: Enter the controller ID (1-3) [1]: Enter the controller name [apic1]: sec-ifc5 Enter address pool for TEP addresses [10.0.0.0/16]: Note: The infra VLAN ID should not be used elsewhere in your environment and should not overlap with any other reserved VLANs on other platforms. Enter the VLAN ID for infra network (2-4094): 4093 Enter address pool for BD multicast addresses (GIPO) [225.0.0.0/15]: Out-of-band management configuration ... Enable IPv6 for Out of Band Mgmt Interface? [N]: Enter the IPv4 address [192.168.10.1/24]: 172.23.142.29/21 Enter the IPv4 address of the default gateway [None]: 172.23.136.1 Enter the interface speed/duplex mode [auto]: admin user configuration ... Enable strong passwords? [Y]: Enter the password for admin: x/GSG/b_APIC_Getting_Started_Guide_Rel_2_x/b_APIC_Getting_Started_Guide_Rel_2_x_chap

No community discussion yet for this question.