2V0-41.20 Exam Questions

A centralized packet analysis tool VM configured to monitor a NSX-T deployment is dropping some of the packets sent to it. Which three actions could minimize the drops? (Choose thr...

Which command is used to change the NSX CLI administrator password?

Which two choices are use cases for Distributed Intrusion Detection? (Choose two.)

An NSX administrator has been tasked with deploying a NSX Edge Virtual machine through an ISO image. Which virtual network interface card (vNIC) type must be selected while creatin...

What needs to be configured on a Tier-0 Gateway to make NSX Edge Services available to a VM on a VLAN-backed logical switch?

Which CLI command does an NSX administrator run on the NSX Manager to generate support bundle logs if the NSX UI is inaccessible?

An NSX administrator would like to export syslog events that capture messages related to NSX host preparation events. Which message ID (msgid) should be used in the syslog export c...

Which CLI command shows syslog on NSX Manager?

Which three protocols could an NSX administrator use to transfer log messages to a remote log server? (Choose three.)

Which command is used to set the NSX Manager's logging-level to debug mode for troubleshooting?

The NSX Control Plane is responsible for which two functions? (Choose two.)

An NSX administrator is using ping to check connectivity between VM1 running on ESXi1 to VM2 running on ESXi2. The ping tests fails. The administrator knows the maximum transmissio...

How is the RouterLink port created between a Tier-1 Gateway and Tier-0 Gateway?

Which two tools could be used to view NSX Policy logs? (Choose two.)

Which discovery protocol is supported for hypervisor transport nodes?

Which two VMware Cloud Management systems are compatible with NSX-T Data Center capabilities? (Choose two.)

An NSX administrator has deployed an NSX Edge on a bare-metal server. Which command registers the NSX Edge with the NSX Manager?

Which tool could be used to inspect the path of a packet in the data plane?

Which two statements are true about the implementation of multicast in NSX-T Data Center? (Choose two.)

Refer to the exhibit. Which NAT type must the NSX-T Data Center administrator create on the Tier-0 or Tier-1 Gateway to allow Web VM to initiate communication with public networks?

How does Traceflow tool identify issues in a network?

Which statement is true about an alarm in a Suppressed state?

A customer has a network where BGP has been enabled and the BGP neighbor is configured on the Tier-0 Gateway. A NSX-T Data Center administrator used the get logical-routers command...

Which two BGP configuration parameters can be configured in the VRF Lite gateways? (Choose two.)

An NSX administrator is troubleshooting a connectivity issue with virtual machines running on an ESXi transport node. Which feature in the NSX UI shows the mapping between the virt...

Which two logical router components span across all transport nodes? (Choose two.)

Which step must be performed before deploying an additional NSX Manager from the NSX-T UI?

Which three functions require a Services Router (SR) component on an Edge node? (Choose three.)

Which NSX CLI command is used to check the GENEVE tunnel status on ESXi transport node?

Which two are valid configurations when attempting to enable L2VPN services in a NSX-T Data Center? (Choose two.)

Which denies all network traffic unless exclusively specified?

Where do you configure the VLANs used in VRF Lite? (Choose two.)

An NSX administrator has configured a load balancer virtual server on a Tier-1 Gateway. In order to advertise the load balancer virtual IP to the Tier-0 Gateway, which route advert...

While planning a NSX-T Data Center deployment with a network administrator, you are told the physical network uses Open Shortest Path First (OSPF) for the Interior Gateway Protocol...

Which technology is leveraged in the NSX Edge for fast packet processing?

Which NSX CLI command is used to change the authentication policy for local users?

An NSX administrator is creating a NAT rule on a Tier-0 Gateway configured in active-active high availability mode. Which NAT rule type is supported for this configuration?

An organization with two data centers is planning an active-active multi-site deployment of NSX-T Data Center. The two data centers have this network connectivity configuration: -...

Which NSX CLI command will enable the SSH service on the NSX Edge node?

An NSX administrator is configuring the KVM hypervisor host as a transport node and wants to apply the Failover Order as a NIC teaming policy. Which profile allows the administrato...

In an enterprise-based single-tier routing topology, which routing component provides east-west routing functionality?

An NSX administrator is planning to deploy a multi-tier routing topology in their NSX-T Data Center environment to provide East-West routing for the VMs. Which routing component mu...

An NSX administrator has observed connectivity issues between the NSX Manager and the KVM Transport Node. Which two log files could be used to troubleshoot the issue on the KVM Tra...

Which three different transport nodes could be configured in the data plane? (Choose three.)

Which statement Is true regarding the audit user account? (Choose two.)

An NSX administrator would like to configure syslog for a KVM transport node. Which host log files could be exported to a remote syslog server?

What are three characteristics of a transport zone? (Choose three.)

Which choice is correct when deploying a NSX Edge in a KVM only environment?

Which tool injects packets and provides various observation points along the packet's path between two NSX-T managed objects?

An NSX administrator is creating a NAT rule on a Tier-0 Gateway configured in active-standby high availability mode. Which two NAT rule types are supported for this configuration?...