CompTIA
220-301 · Question #852
How can the IDE hard drive be set to use a specific connector on the cable?
The correct answer is A. by setting jumpers for Cable Select. See the full explanation below for the reasoning.
Question
How can the IDE hard drive be set to use a specific connector on the cable?
Options
- Aby setting jumpers for Cable Select
- Bby plugging the IDE cable into the second connector on the motherboard
- Cby setting jumpers for Slave
- Dby setting jumpers for Master
How the community answered
(35 responses)- A74% (26)
- B9% (3)
- C3% (1)
- D14% (5)
Community Discussion
No community discussion yet for this question.