210-260 · Question #40
Which command causes a Layer 2 switch interface to operate as a Layer 3 interface?
The correct answer is D. no switchport. Configure routed ports by putting the interface into Layer 3 mode with the no switchport interface configuration command. Then assign an IP address to the port, enable routing, and assign routing protocol characteristics by using the ip routing and router protocol global…
Question
Which command causes a Layer 2 switch interface to operate as a Layer 3 interface?
Options
- Ano switchport nonnegotiate
- Bswitchport
- Cno switchport mode dynamic auto
- Dno switchport
How the community answered
(29 responses)- A3% (1)
- B3% (1)
- C7% (2)
- D86% (25)
Explanation
Configure routed ports by putting the interface into Layer 3 mode with the no switchport interface configuration command. Then assign an IP address to the port, enable routing, and assign routing protocol characteristics by using the ip routing and router protocol global configuration 2_55_se/configuration/guide/scg3750/swint.html
Topics
Community Discussion
No community discussion yet for this question.