The firmware for the primary codec of a Cisco TelePresence System 3010 is being upgraded. Which codec CLI command could be used to check on the progress of the update?

The correct answer is C. show upgrade detail. On the Cisco TelePresence System 3010 primary codec (which runs a Linux-based CLI), the command 'show upgrade detail' is used to check the current status and progress of a firmware upgrade in progress. It provides detailed output about the upgrade stage, percentage complete…

Endpoint Configuration

Question

Options

Autils upgrade display
Butils system version
Cshow upgrade detail
Dshow system upgrade

How the community answered

(47 responses)

A
4% (2)
B
2% (1)
C
87% (41)
D
6% (3)

Explanation

On the Cisco TelePresence System 3010 primary codec (which runs a Linux-based CLI), the command 'show upgrade detail' is used to check the current status and progress of a firmware upgrade in progress. It provides detailed output about the upgrade stage, percentage complete, and any errors encountered. 'utils upgrade display' (A) is not a valid TelePresence codec command. 'utils system version' (B) shows the currently installed version but does not report on an in-progress upgrade. 'show system upgrade' (D) is not the correct syntax for this platform; the proper command structure uses 'show upgrade detail'.

Topics

#firmware upgrade#CLI commands#TelePresence 3010#codec management

Community Discussion

No community discussion yet for this question.

Full 210-065 Practice