An Exadata storage server physical disk on an X9M-2 high-capacity full rack entered the predictive failure state. Which two steps must you perform to replace this failed physical disk?

Question

Options

• AReplace the failed physical disk.
• BAdd the griddisks back into the ASM diskgroup they used to be a member of.
• CIdentify the griddisks located on the failed physical disk and drop them from the associated ASM
• DRebalance the data on the effected griddisks before performing a manual drop command.
• ECreate a new celldisk and new griddisks on the replaced physical disk.
• FVerify that the griddisks located on the physical disk have been successfully dropped from the

• A
  70% (26)
• B
  16% (6)
• D
  3% (1)
• E
  3% (1)
• F
  8% (3)

Explanation

Once the physical disk has been replaced, you will need to create a new celldisk and griddisks on the replaced physical disk. After the griddisks have been dropped from the associated ASM diskgroups, you can then add the griddisks back into the ASM diskgroup they used to be a member of and rebalance the data on the effected griddisks. Finally, you should verify that the griddisks located on the physical disk have been successfully dropped from the associated ASM

No community discussion yet for this question.