1Z0-884 Exam Questions

The clrg show command shows the following output for pippo-rg resource group. Resource group nfs-rg is configured to run only on node fachiro. Resource Group: pippo-rg RG_descripti...

When configuring Veritas Cluster Volume Manager for use with a two-node Oracle RAC Sun Cluster 3.2 install, which node can configure the shared disk group?

Which are three reasons to disable automatic quorum device configuration in a two-node cluster? (Choose three.)

You need to remove the Veritas Volume Manager volume named nfsvol in the nfsdg disk group which is mounted on /nfs. Which set of commands are used to perform this procedure?

You have two adapters that you want to configure in the same IPMP group. Neither of them are yet configured into any IPMP group. The cluster nodes are already configured. Which tas...

You just created a Solaris Volume Manager diskset from the shared storage containing two disks, one from each of two arrays. You added two connected nodes as mediators for the disk...

In Veritas Volume Manager 4.x or 5.x, once you encapsulate your boot device it goes into a disk group. This group historically was called rootdg. What is the name of the link to th...

Occasionally you may need to rebuild your cluster. If you rebuilt a cluster named "dev" without removing the old quorum server information, you may want to clean up the old quorum...

Which IPMP restriction for multiple adapters in an IPMP group is no longer a restriction in Solaris 10?

How can you name Solaris Volume Manager disksets that include disks from shared storage?

When configuring the RAC framework Resource Group for an Oracle RAC database instance, what do the parameters of Maximum_primaries=, Desired_primaries= refer to?

Which configuration can be used with ZFS and Sun Cluster 3.2?

One of the cluster nodes is at the ok boot prom prompt. You want to boot that node to multiuser and into non-cluster mode. Which command will accomplish this?

Which two name service lookup entries are modified with an entry of cluster in /etc/nsswitch.conf for Sun Cluster 3.2? (Choose two.)

There are various ways to interact with Sun Cluster 3.2 to do daily administration. Which method is prohibited?

Which two components are part of the Sun Cluster 3.2 software stack? (Choose two.)

After the cluster administrator has installed the Sun Cluster 3.2 packages, you configure the Sun Cluster 3.2 framework. This can be done in various ways. Which configuration metho...

Suppose you have a Veritas Volume Manager disk group named appdg with default settings registered using: #cldg create -t vxvm -n node1,node2 appdg. You are now asked to configure t...

What is the name of the cluster console package that the cluster administrator will load onto the administrative workstation?

Before you can configure your cluster, what must you do on each node to prepare for the global devices device files?

You have a two-node cluster configured. Node one is out of the cluster. You make changes to node two (add resource groups and disk device groups). You now shut down node two and tr...

An administrator is deciding whether to use a global file system or a failover file system for an application. Which is a good reason to use a global file system?

Which describes the type of application data storage required in a multi-node cluster NOT using controller-based replication?

Which two are valid reasons to disable automatic quorum configuration? (Choose two.)

When using ZFS in the cluster environment, you generally do not need any other volume manager to manage your data storage. Instead, you create pools of storage to manage the file s...

During the scinstall process the cluster administrator has to configure the cluster transport. Which step does the cluster administrator have to perform in a typical cluster config...

Sun Cluster 3.2 can take advantage of the new ZFS file system available with Solaris 10. Which two new features are available with ZFS and Sun Cluster 3.2? (Choose two.)

What are the requirements if you want to use only IPV6 test address for your public network adapters, and no IPV4 test address?

What is the minimum number of nodes required to make a highly available cluster?

A system administrator has a two-node cluster to which it becomes necessary to add a third node. Once the hardware has been connected, which two steps are required to add the new n...

Which three are characteristics of the High Availability environment provided by Sun Cluster? (Choose three.)

Which two statements identify the correct boot device restrictions? (Choose two.)

A diskset has been created in a two-node cluster with the incorrect name. No disks have been added to it. How does the cluster administrator remove the diskset from the cluster fra...

The quorum mechanism and voting system are important parts of Sun Cluster. What is the majority formula to have a working cluster?

Which two Veritas Volume Manager packages need to be installed on all nodes connected to the shared storage? (Choose two.)

A customer has a resource group called nfs-rg with a SUNW.nfs resource called nfs-rs. They want to check how the Failover_mode property has been set. Which is the correct command u...

During the scinstall process there are many steps executed automatically. Which two execute automatically when using scinstall on a Solaris 9 system? (Choose two.)

You want to create separate non-global zones on different nodes, and be able to fail over an application between the two zones. What would be the advantage of using the same zone n...

If you administer a cluster with HA-Oracle you should understand some principles of the HA- Oracle fault monitor. Which part is NOT performed by the Oracle fault monitor?

Suppose you have two nodes called node1 and node2, and each of them has a non-global zone running called zone1. Which two commands register a failover resource group named apache-r...

When would you use a Veritas Volume Manager CDS disk in the bootdg group?

You configure Oracle10g RAC in Sun Cluster 3.2 with the data on a global file system. What will happen?

Before installing Sun Cluster 3.2 software with Solaris Volume Manager on the nodes that will make up the cluster, which three requirements must be met? (Choose three.)

You set up your cluster using the default 172.16.x.x range for the cluster transport. Yet these same IP addresses are in use on machines in a department that you need to access acr...

Solaris 10 allows resource allocation to users by assigning them projects. Consider having to automatically assign a project to an Oracle user, to start your HA-Oracle database. Wh...

Which component of Sun Cluster 3.2 provides global naming consistency for shared storage?

Every resource in Sun Cluster 3.2 has to have a resource type. Some of the resource types are pre-registered, and most of them you have to register. Which resource type listed belo...

When using Veritas Volume Manager in the cluster, why would you choose to use Dirty Region Logging (DRL) for your mirrored volumes?

When using ZFS for your shared storage within the cluster, how do you specify the file system mountpoint?

You have a three-node cluster and have put one node into maintenance mode. What do you need to do to give the node its vote back and bring it back into the cluster?