When issuing the zonestat 2 1h is command, the following information is displayed: Which two options accurately describe the statistics contained in the output?

Question

Exhibit

Options

• Adbzone is using 0.21% of the total CPU resource available in the zone's processor set.
• Bdbzone is using 0.21% of the global zone's total CPU.
• Cdbzone is using 5.48% of the total physical memory that has been allocated to the zone.
• Ddbzone is using 2.37% of the global zone's total virtual memory.
• EThe network is being utilized 100% with no physical bandwidth remaining.

• A
  79% (38)
• B
  4% (2)
• D
  13% (6)
• E
  4% (2)

Explanation

The amount of cpu used as a percentage of the total cpu in a processor-set to which the zone is bound. A zone can only have processes bound to multiple processor sets if it is the global zone, or if psrset(1m) psets are used. If multiple binding are found for a zone, it's %PART is the fraction used of all bound psets. For [total] and [system], %PART is the percent used of all cpus on the Note: The zonestat utility reports on the cpu, memory, and resource control utilization of the currently running zones. Each zone's utilization is reported both as a percentage of system resources and the zone's configured limits. The zonestat utility prints a series of interval reports at the specified interval. It optionally also prints one or more summary reports at a specified interval.

No community discussion yet for this question.