Citrix
1Y0-A28 · Question #40
Scenario: The network engineer is setting up a new NetScaler using a direct connection. Three networks are connected to the NetScaler. After initial configuration and restart, the engineer would…
The correct answer is D. From the command-line interface 'show route'. See the full explanation below for the reasoning.
Question
Scenario: The network engineer is setting up a new NetScaler using a direct connection. Three networks are connected to the NetScaler. After initial configuration and restart, the engineer would like to confirm the routing table entries. From which location and which command should the engineer run to display the routing table?
Options
- AFrom the shell 'netstat -r'
- BFrom the shell 'route monitor'
- CFrom the command-line interface 'show pbr'
- DFrom the command-line interface 'show route'
How the community answered
(60 responses)- A12% (7)
- B5% (3)
- C2% (1)
- D82% (49)
Community Discussion
No community discussion yet for this question.