Citrix
1Y0-A26 · Question #3
Scenario: An administrator notices a duplex mismatch on the network interface card (NIC) which is configured as the management interface. The administrator realizes that the switch was set to 100…
The correct answer is C. Use the xe pif-param-set command to set other-config:ethtool-autoneg=off. See the full explanation below for the reasoning.
Question
Scenario: An administrator notices a duplex mismatch on the network interface card (NIC) which is configured as the management interface. The administrator realizes that the switch was set to 100 full, but XenServer auto-configured the NIC to 100 half, autoneg=on. How can the administrator ensure the XenServer host does NOT auto-configure the NIC in the future?
Options
- AChange the NIC properties in the xsconsole.
- BUse the xe pif-configure-ip command to disable auto-configuration.
- CUse the xe pif-param-set command to set other-config:ethtool-autoneg=off.
- DAssign a new NIC to the management interface within the XenCenter Network tab.
How the community answered
(32 responses)- A6% (2)
- B3% (1)
- C75% (24)
- D16% (5)
Community Discussion
No community discussion yet for this question.