Scenario: A network administrator has set up two NetScalers in HA. However, when the administrator checks the HA nodes, the secondary unit shows as DOWN Details were gathered from the secondary unit…

Scenario: A network administrator has set up two NetScalers in HA. However, when the administrator checks the HA nodes, the secondary unit shows as DOWN Details were gathered from the secondary unit and are displayed below. ID:0 IP Address: 12.44.107 Node State: NOT UP Master State:Secondary Fail-Safe Mod: OFF INC State: DISABLED Synchronization State: SUCCESS HA Propagation: ENABLED Citrix 1Y0-A21 Exam Enabled Interfaces: 1/5 1/6 1/7 1/8 Disabled Interfaces: 1/1 1/2 1/3 1/4 SSL Card status: UP HA Monitor on Interfaces: 1/6 1/7 1/8 Interfaces on which heartbeats are not seen: 1/5 1/6 Interfaces causing partial failure: 1/6 HelloInterval (msecs): 200 Dead Interval (sees): 3 Node in Secondary state for 15 Min(s) 0 Sec(s) ----------------------------------------------------------------------- ----------- ID: 1 IP Address: 12.12.44.106 Node State: UP Master State: Primary Fail-Safe Mode: OFF INC State: DISABLED Synchronization State: ENABLED HA Propagation: ENABLED Enabled Interfaces: 1/5 1/6 1/7 1/8 Disabled Interfaces: 1/1 1/2 1/3 1/4 SSL Card status: UP HA Monitor on Interfaces: 1/7 1/8 Interfaces on which heartbeats are not seen: 1/5 1/6 Given this information, which two options could the administrator do to bring Node 0 to the UP state? (Choose two.)