Which command will allow a NetScaler Engineer to change the NetScaler IP (NSIP) from the command-line interface?

The correct answer is C. set ns config -ipaddress 10.100.10.100 -netmask 255.255.255.0. Exam Questions, Study Guides, Practice Tests. Lead the way to help you pass any IT Certification exams, 100% Pass Guaranteed or Full Refund. Especially Cisco, CompTIA, Citrix, EMC, HP, Oracle, VMware, Juniper, Check Point, LPI, Nortel, EXIN and so on. Our Slogan: First Test…

Advanced Administration

Question

Options

Aadd ns ip 10.100.10.100 255.255.255.0 -type SNIP
Badd ns ip 10.100.10.100 255.255.255.0 -type NSIP
Cset ns config -ipaddress 10.100.10.100 -netmask 255.255.255.0
Dset ns ip 10.100.10.100 -netmask 255.255.255.0 -mgmtaccess enabled

How the community answered

(24 responses)

A
4% (1)
B
8% (2)
C
71% (17)
D
17% (4)

Explanation

Exam Questions, Study Guides, Practice Tests. Lead the way to help you pass any IT Certification exams, 100% Pass Guaranteed or Full Refund. Especially Cisco, CompTIA, Citrix, EMC, HP, Oracle, VMware, Juniper, Check Point, LPI, Nortel, EXIN and so on. Our Slogan: First Test, First Pass. Help you to pass any IT Certification exams at the first try. You can reach us at any of the email addresses listed below. Any problems about IT certification or our products, you could rely upon us, we will give you satisfactory answers in 24 hours.

Topics

#NSIP configuration#set ns config#CLI command#IP management

Community Discussion

No community discussion yet for this question.

Full 1Y0-351 Practice