Citrix
1Y0-351 · Question #233
Which command must a NetScaler Engineer run at the command-line interface to enable a Link Aggregation Control Protocol (LACP) channel?
The correct answer is C. Use "set interface" with lacpKey parameter. See the full explanation below for the reasoning.
Question
Which command must a NetScaler Engineer run at the command-line interface to enable a Link Aggregation Control Protocol (LACP) channel?
Options
- AUse "set lacp" with sysPriority parameter.
- BUse "set lacp" with ownerNode parameter.
- CUse "set interface" with lacpKey parameter.
- DUse "set interface" with lacpPriority parameter.
How the community answered
(45 responses)- A13% (6)
- B4% (2)
- C80% (36)
- D2% (1)
Community Discussion
No community discussion yet for this question.