Scenario: A NetScaler Engineer connected a new NetScaler MPX appliance to the network. However, some of the interfaces were blocked on the uplink switch. The engineer needs to perform a network packet trace on the NetScaler appliance. For troubleshooting purposes, the engineer needs to separate trace files for each interface. The engineer executed the following command from the NetScaler CLI:

start nstrace -perNIC ENABLED However, NetScaler created a single trace file. What should the engineer do to produce separate trace files for each interface?

Question

Scenario: A NetScaler Engineer connected a new NetScaler MPX appliance to the network. However, some of the interfaces were blocked on the uplink switch. The engineer needs to perform a network packet trace on the NetScaler appliance. For troubleshooting purposes, the engineer needs to separate trace files for each interface. The engineer executed the following command from the NetScaler CLI:

start nstrace -perNIC ENABLED However, NetScaler created a single trace file. What should the engineer do to produce separate trace files for each interface?

Accepted Answer

C. Specify the tcpdump parameter.

Answer

A. Specify the nodes parameter.

Answer

B. Use the nsconmsg command.

Answer

D. Use the nstracemerge.sh command.

Scenario: A NetScaler Engineer connected a new NetScaler MPX appliance to the network. However, some of the interfaces were blocked on the uplink switch. The engineer needs to perform a network…

Question

Options

How the community answered

Community Discussion