Check_Point
156-915.77 · Question #57
(Topic 4) Your perimeter Security Gateway's external IP is 200.200.200.3. Your network diagram shows: Required: Allow only network 192.168.10.0 and 192.168.20.0 to go out to the Internet, The local…
The correct answer is B. Create an Address Range object, starting from 192.168.10.1 to 192.168.20.254. Enable. See the full explanation below for the reasoning.
Question
- (Topic 4)
Your perimeter Security Gateway’s external IP is 200.200.200.3. Your network diagram shows:
Required: Allow only network 192.168.10.0 and 192.168.20.0 to go out to the Internet, The local network 192.168.1.0/24 needs to use 200.200.200.3 to go out to the Internet. Assuming you enable all the settings in the NAT page of Global Properties, how could you achieve these requirements?
Options
- ACreate network objects for 192.168.10.0/24 and 192.168.20.0/24. Enable Hide NAT on
- BCreate an Address Range object, starting from 192.168.10.1 to 192.168.20.254. Enable
- CCreate a network object 192.168.0.0/16. Enable Hide NAT on the NAT page. Enter
- DCreate two network objects: 192.168.10.0/24 and 192.168.20.0/24. Add the two network
How the community answered
(52 responses)- A15% (8)
- B73% (38)
- C8% (4)
- D4% (2)
Community Discussion
No community discussion yet for this question.