156-836 Question #94: Real Exam Question with Answer & Explanation

The correct answer is A. 3-4-2-6-5-7-1. Option A (3-4-2-6-5-7-1) is correct because it follows the only logical physical-to-logical progression: you must first connect via serial console (3) since no IP exists yet, then use that console session to assign a management IP (4) and configure the default gateway (2), which

Maestro Architecture & Deployment

Question

What is the basic installation sequence of the Orchestrator in case of single Orchestrator? 1. Create a Security Group 2. Configure Default Gateway 3. Connect with Serial Console cable to the Orchestrator 4. Configure IP for one of its Management interfaces 5. Connect an appliance to a downlink port 6. Change Orchestrator amount to 1 7. Browse to the Orchestrator's WebUI

Options

A3-4-2-6-5-7-1
B3-1-7-2-4-6-5
C1-4-2-5-7-3-6
D7-4-2-5-3-1-6

Explanation

Option A (3-4-2-6-5-7-1) is correct because it follows the only logical physical-to-logical progression: you must first connect via serial console (3) since no IP exists yet, then use that console session to assign a management IP (4) and configure the default gateway (2), which enables network reachability. Only after network access is established can you change the orchestrator count (6), connect a downlink appliance (5), browse the WebUI (7), and finally create a security group (1) through the GUI.

Why distractors fail: Option B places security group creation (1) and WebUI access (7) before any IP or gateway is configured - you cannot reach a WebUI with no IP address. Option C starts with security group creation (1) before any physical or network setup exists, making it impossible. Option D begins with WebUI access (7) as step one, which is entirely unreachable before basic network configuration.

Memory tip: Use the phrase "Console → Network → Logic" - always begin with the physical serial console, then build network settings (IP, gateway), and only then perform logical/software configuration (orchestrator count, appliances, WebUI, security groups).

Topics

#Orchestrator Installation#Management Interface Configuration#Console Access#Hardware Setup

Community Discussion

No community discussion yet for this question.

Full 156-836 Practice