156-835 Exam Questions

What is the Orchestrator?

What is the Iterator process?

What is the throughput penalty of Security Group?

Which is a valid requirement for a supported Maestro appliance?

Which setting is required in order to connect an appliance with 40Gbps downlink interface and DAC to the Orchestrator MHO-140?

What does the lldpctl command do?

In case of VSX: What is the right command to see overall performance details of all Appliances within the Security Group and all Virtual Systems?

When running asg perf -v in a Dual-Site environment, we can see only Appliances from one of the sites. That means we're working in:

How many power supplies are presented on MHO-170?

What command should be used for collecting diagnostic information about the orchestrator?

In case of Correction, where is information about Owner stored?

On MHO-170 ?In default configuration, what are GAIA names of Security Group Management ports?

What is a Security Group?

What command will be used for updating fwkern.conf file on all Appliances within Security Group?

What is the default range of physical ports for downlinks on Orchestrator MHO-170?

What is the default IP range of Sync network (with no increment)?

What is the minimal amount of cables needed in order to connect an Appliance to an Orchestrator?

What is the maximum amount of Appliances within the same Security Group?

What cannot be learned from the output of asg perf -v -p command?

What type of cluster can a Security Group can be compared to?

What is the distribution mode?

How many orchestrators may Dual-Site include''

What does the command'g_all' do?

Which file on Appliance includes information about Security Group?

Complete the sentence: Orchestrators works as...

What is the default IP range of CIN network (with no increment)?

There is a Security group of 10 Appliances and all of them are up and running. How many Appliances within a Security Group keep the same connection in its connection table in case...

In order to set Site (chassis) priority per VS, following command should be used:

What kinds of transceivers are supported on Orchestrator MHO-170?

What cannot be learned from the output of asg monitor command?

What is a downlink interface used for?

When running ifconfig command on an Appliance, there are interfaces shown in the list: ethl-Sync and eth2-Sync. What is the purpose of these interfaces?

There are two 10Gbps dual-port NICs and one 40Gbps NIC installed on a 23800 Appliance in slots 1, 2 and 3 accordingly. Which interfaces should be connected to Orchestrator 1 for do...

What cannot be a reason for DETACHED status of Appliance when running asg monitor command?

What is the difference between Dual-Site and Multi-Room?

What is the minimal requirement for a Security Group?

For a VSX configuration ?Which statement is wrong?

There are two 10Gbps dual-port NIC installed on a 6800 appliance. Which interfaces should be connected to Orchestrator 1 for downlinks' intra-orchestrator redundancy when using two...

What is the purpose of RJ-45 connectors located at the front panel of the Orchestrator MHO-170?

Splitter cannot be used __________.

What will happen in case of NAT of the traffic passing through Management network?

One single Appliance supports 1M concurrent connections. How many concurrent connections will support Security Group of 2 Appliances?

What does asg monitor command do?

There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there's no NAT and no VPN, what would...

Which licenses should be issued for the Orchestrator?

What is the Sync network on Appliances used for?

Complete the sentence: When using a Break-out cable...

What is the max amount of Orchestrators in Dual-site setup?

What cannot be a reason for "Failed to get remote orchestrator interfaces" error message, when clicking on "Orchestrator" in WebUI?

What is an uplink interface used for?