Check_Point
156-581 · Question #52
After deploying a Hide NAT for a new network, users are unable to access the Internet. What command would you use to check the internal NAT behavior?
The correct answer is D. fw ctl zdebug + xlate xltrc nat. See the full explanation below for the reasoning.
Question
After deploying a Hide NAT for a new network, users are unable to access the Internet. What command would you use to check the internal NAT behavior?
Options
- Acp ctl zdebug + xlate xltrc nat
- Bcp ctl kdebug + xlate xltrc nat
- Cfw ctl kdebug + xlate xltrc nat
- Dfw ctl zdebug + xlate xltrc nat
How the community answered
(57 responses)- A16% (9)
- B9% (5)
- C4% (2)
- D72% (41)
Community Discussion
No community discussion yet for this question.