Check_Point
156-315.81 · Question #343
After the initial installation on Check Point appliance, you notice that the Management-interface and default gateway are incorrect. Which commands could you use to set the IP to 192.168.80.200/24…
The correct answer is A. set interface Mgmt ipv4-address 192.168.80.200 mask-length 24 set static-route default nexthop. See the full explanation below for the reasoning.
Question
After the initial installation on Check Point appliance, you notice that the Management-interface and default gateway are incorrect. Which commands could you use to set the IP to 192.168.80.200/24 and default gateway to 192.168.80.1.
Options
- Aset interface Mgmt ipv4-address 192.168.80.200 mask-length 24 set static-route default nexthop
- Bset interface Mgmt ipv4-address 192.168.80.200 255.255.255.0 add static-route 0.0.0.0. 0.0.0.0
- Cset interface Mgmt ipv4-address 192.168.80.200 255.255.255.0 set static-route 0.0.0.0. 0.0.0.0
- Dset interface Mgmt ipv4-address 192.168.80.200 mask-length 24 add static-route default nexthop
How the community answered
(30 responses)- A70% (21)
- B10% (3)
- C3% (1)
- D17% (5)
Community Discussion
No community discussion yet for this question.