Check_Point
156-315.81.20 · Question #134
To fully enable Dynamic Dispatcher on a Security Gateway:
The correct answer is D. run "fw ctl muitik dynamic_dispatching on" and then reboot. See the full explanation below for the reasoning.
Question
To fully enable Dynamic Dispatcher on a Security Gateway:
Options
- AUsing cpconfig, update the Dynamic Dispatcher value to "full" under the CoreXL menu
- BEdit /proc/interrupts to include multik set_mode 1 at the bottom of the file, save, and reboot
- Crun fw ctl multik set_mode 1 in Expert mode and then reboot
- Drun "fw ctl muitik dynamic_dispatching on" and then reboot
How the community answered
(37 responses)- A3% (1)
- B5% (2)
- C11% (4)
- D81% (30)
Community Discussion
No community discussion yet for this question.