Check_Point
156-315.76 · Question #163
State Synchronization is enabled on both members in a cluster, and the Security Policy is successfully installed. No protocols or services have been unselected for selective sync. Review the fw tab…
The correct answer is A. Members A and B are not synchronized, because #VALS in the connections table are not close. See the full explanation below for the reasoning.
Question
State Synchronization is enabled on both members in a cluster, and the Security Policy is successfully installed. No protocols or services have been unselected for selective sync. Review the fw tab -t connections -s output from both members. Is State Synchronization working properly between the two members?
Exhibit
Options
- AMembers A and B are not synchronized, because #VALS in the connections table are not close.
- BMembers A and B are not synchronized, because #PEAK for both members is not close in the
- CMembers A and B are synchronized, because #SLINKS are identical in the connections table.
- DMembers A and B are synchronized, because ID for both members is identical in the connections
How the community answered
(36 responses)- A78% (28)
- B3% (1)
- C6% (2)
- D14% (5)
Community Discussion
No community discussion yet for this question.