Check_Point
156-315.71 · Question #179
State Synchronization is enabled on both members in a cluster, and the Security Policy is successfully installed. No protocols or services have been unselected for selective sync. The following is…
The correct answer is D. Members A and B are not synchronized, because #VALS in the connections table are not close. See the full explanation below for the reasoning.
Question
State Synchronization is enabled on both members in a cluster, and the Security Policy is successfully installed. No protocols or services have been unselected for selective sync. The following is the fw tab -t connections -s output from both members:
Is State Synchronization working properly between the two members? Check Point 156-315.71 Exam
Exhibits
Options
- AMembers A and B are synchronized, because #SLINKS are identical in the connections table.
- BMembers A and B are synchronized, because ID for both members is identical in the connections table.
- CMembers A and B are not synchronized, because #PEAK for both members is not close in the connections
- DMembers A and B are not synchronized, because #VALS in the connections table are not close.
How the community answered
(20 responses)- A10% (2)
- B5% (1)
- C5% (1)
- D80% (16)
Community Discussion
No community discussion yet for this question.