Check_Point
156-215.81 · Question #435
After the initial installation on Check Point appliance, you notice that the Management interface and default gateway are incorrect. Which commands could you use to set the IP to 192.168.80.200/24…
The correct answer is A. set interface Mgmt ipv4-address 192.168.80.200 mask-length 24 set static-route default nexthop. See the full explanation below for the reasoning.
Question
After the initial installation on Check Point appliance, you notice that the Management interface and default gateway are incorrect. Which commands could you use to set the IP to 192.168.80.200/24 and default gateway to 192.168.80.1.
Options
- Aset interface Mgmt ipv4-address 192.168.80.200 mask-length 24 set static-route default nexthop
- Badd interface Mgmt ipv4-address 192.168.80.200 255.255.255.0 add static-route 0.0.0.0.0.0.0.0
- Cset interface Mgmt ipv4-address 192.168.80.200 255.255.255.0 add static-route 0.0.0.0.0.0.0.0
- Dadd interface Mgmt ipv4-address 192.168.80.200 mask-length 24 add static-route default nexthop
How the community answered
(66 responses)- A76% (50)
- B8% (5)
- C5% (3)
- D12% (8)
Community Discussion
No community discussion yet for this question.