Check_Point
156-215.75 · Question #68
When using SecurePlatform, it might be necessary to temporarily change the MAC address of the interface eth 0 to 00:0C:29:12:34:56. After restarting the network the old MAC address should be active…
The correct answer is B. As expert user, issue these commands. See the full explanation below for the reasoning.
Question
When using SecurePlatform, it might be necessary to temporarily change the MAC address of the interface eth 0 to 00:0C:29:12:34:56. After restarting the network the old MAC address should be active. How do you configure this change?
Options
- AOpen the WebUI, select Network > Connections > eth0. Place the new MAC address in the field
- BAs expert user, issue these commands:
- CAs expert user, issue the command:
- DEdit the file /etc/sysconfig/netconf.c and put the new MAC address in the field (conf
How the community answered
(46 responses)- A15% (7)
- B76% (35)
- C2% (1)
- D7% (3)
Community Discussion
No community discussion yet for this question.