Check_Point
156-215.75 · Question #481
You install and deploy SecurePlatform with default settings. You allow visitor Mode in the Gateway object's Remote Access properties and install policy, but SecureClient refuses to connect. What is…
The correct answer is D. The WebUI on SecurePlatform runs on port 443 (HTTPS). When you configure Visitor Mode it cannot. See the full explanation below for the reasoning.
Question
You install and deploy SecurePlatform with default settings. You allow visitor Mode in the Gateway object's Remote Access properties and install policy, but SecureClient refuses to connect. What is the cause of this?
Options
- ASet the Visitor Mode Policy > Global Properties > Remote-Access > VPN ?Advanced
- BOffline mode is not configured
- CYou need to start SSL Network Extended first, then use Visitor Mode
- DThe WebUI on SecurePlatform runs on port 443 (HTTPS). When you configure Visitor Mode it cannot
How the community answered
(36 responses)- A6% (2)
- B11% (4)
- C3% (1)
- D81% (29)
Community Discussion
No community discussion yet for this question.