Check_Point
156-215.75 · Question #314
After installing Security Gateway R75, you discover that one port on your Intel Quad NIC on the Security Gateway is not fetched by a Get Topology request. What is the most likely cause and solution?
The correct answer is D. If an interface is not configured, it is not recognized. Assign an IP address and subnet mask using the WebUI. See the full explanation below for the reasoning.
Question
After installing Security Gateway R75, you discover that one port on your Intel Quad NIC on the Security Gateway is not fetched by a Get Topology request. What is the most likely cause and solution?
Options
- AYour NIC driver is installed but was not recognized. Apply the latest Secure Plat form R75 Hotfix
- BThe NIC is faulty. Replace it and reinstall.
- CMake sure the driver for your particular NIC is available, and reinstall. You will be prompted for the driver.
- DIf an interface is not configured, it is not recognized. Assign an IP address and subnet mask using the WebUI.
How the community answered
(27 responses)- A11% (3)
- B4% (1)
- C4% (1)
- D81% (22)
Community Discussion
No community discussion yet for this question.