Check_Point
156-215.71 · Question #142
After filtering a fw monitor trace by port and IP, a packet is displayed three times; in the i, I, and o inspection points, but not in the O inspection point. Which is the likely source of the issue?
The correct answer is D. It is an issue with NAT. See the full explanation below for the reasoning.
Question
After filtering a fw monitor trace by port and IP, a packet is displayed three times; in the i, I, and o inspection points, but not in the O inspection point. Which is the likely source of the issue?
Options
- AThe packet has been sent out through a VPN tunnel unencrypted.
- BAn IPSO ACL has blocked the outbound passage of the packet.
- CA SmartDefense module has blocked the packet
- DIt is an issue with NAT
How the community answered
(30 responses)- A3% (1)
- B7% (2)
- C17% (5)
- D73% (22)
Community Discussion
No community discussion yet for this question.