You are about to add an IPv6 address to an interface with CLISH, but the system generates a message stating that the command is unknown. What could be the reason of this behavior?

Question

Options

• AYou have to install the IPv6 SKU license onto your Security Gateway
• BYou must activate the IPv6 protocol stack with the "set ipv6-state on" command in CLISH
• CYou have to tick the IPv6 check box under the topology section of your gateway object within
• DYou have to install the IPv6 SKU license onto your Security Management Server

• A
  8% (2)
• B
  72% (18)
• C
  16% (4)
• D
  4% (1)

No community discussion yet for this question.